Anilam Wizard 900 - Keyboard Entry Error

198 pages

Save Page as PDF

To Next Page

To Previous Page

Keyboard Entry Error

If you enter an incorrect value, press the axis key again to clear the axis display. If you

enter too many numbers on an axis, the DRO display reverts to zero on that axis. When

this happens, enter the correct number again.

Main Page

Table of Contents3
Contents4
Introducing the Wizard7
The ANILAM Wizard 450/450L Keypad and Display Windows8
The ANILAM Wizard 450/450L Back Panel9
First-Time User Checklist11
About this Manual13
Function Code List14
Beeper OFF/ON - F 2117
Keyboard Entry Error18
Inch/Metric Conversion19
Decimal Degree to Degree-Minutes-Seconds Conversion20
Plus/Minus (±) Key21
Absolute/Incremental (ABS/INCR) Key22
Presetting a Dimension23
Recalling a Preset Dimension24
Clearing a Preset Dimension25
Resetting an Axis to Zero26
Axis Reset Only - F 1627
Absolute Zero Set - F 0129
Absolute Zero Set at Reference Mark - F 9030
Evertrack TM Mode - F 0231
Last Position Save/Recall - F 10/F 1136
Adding/Subtracting Values37
Dividing an Axis Value by 238
Centering Key39
Radius/Diameter Per Axis - F 0541
Setting a Correction Factor - F 0343
100-Point Axis Error Compensation - F 80/F 8145
Measure the Axis45
Selecting the Compensation Table, Entering an Axis Compensation47
Key Functions for Compensation Table50
Deleting a Compensation Value Table51
Axis Error Compensation ON/OFF52
Correction Factor OFF/ON - F 0453
Approaching Zero Indicator54
Approaching Zero - F 0655
Approaching Zero Range - F 0757
Approaching Zero Audio ON/OFF - F 0859
Connecting the Edge Sensor Probe60
Edge Sensor Probe - F 0961
Feedrate ON/OFF - F 2663
Job Clock ON/OFF - F 3464
Parameter Settings - F 2066
Setting up Encoder Parameters66
Metric Linear Encoders68
Inch Linear Encoders (BT or JB Linear Encoders)72
Rotary Encoders73
Display DIM OFF/ON - F 22/ F 2377
Axis Designation - F 2478
Select Language - F 9979
Linear Encoder Error Detect OFF/ON - F 40/F 4180
Diagnostics - F 4581
Advanced (ADV) Functions Key84
Help Function84
Bolt-Hole Pattern Function (450 Only)86
Partial Bolt-Hole Pattern88
Full Bolt-Hole Pattern (450 Only)92
Recalling Bolt-Hole Pattern Function (450 Only)96
Linear-Hole/Frame-Hole Pattern Function (450 Only)99
Recalling Linear-Hole/Frame-Hole Function (450 Only)104
Taper Calculator Function (450L Only)107
Enter Datum114
Enter Datum (Alternate Method)117
Recall Datum119
Clear Datum - F 31120
Enter Tool Offset121
Recall Tool Offset123
Modify Tool Offset - F 35124
Clear Tool Offset - F 32125
Output Connections (with I/O Option Only)143
Input Connections (with I/O Option Only)144
Zero Output ON/OFF (with I/O Option Only) - F 33145
Zero Output Time Select (with I/O Option Only) - F 25147
Interface (with I/O Option Only)148
Setup (with I/O Option Only) - F 27149
ON/OFF (with I/O Option Only) - F 28152
Printing Axis Values (with I/O Option Only)153
Remote Operation (with I/O Option Only)154

Anilam Wizard 900 - Keyboard Entry Error

Table of Contents

Related product manuals