8
Function Code List
You can access most DRO features using function codes. Function codes are codes
entered by pressing the Function key (F) and then pressing the two-digit code for the
feature. The following table lists the function codes available with your DRO. The page
number indicates where the function is described in this manual.
Code Description Page
F 01 Absolute Zero Set 23
F 02 EverTrack
TM
Mode 25
F 03 Setting a Correction Factor 37
F 04 Correction Factor OFF/ ON 47
F 05 Radius/Diameter per Axis 35
F 06 Approaching Zero 49
F 07 Approaching Zero Range 51
F 08 Approaching Zero Audio ON/OFF 53
F 09 Edge Sensor Probe 55
F 10 Last Position Save 30
F 11 Last Position Recall 30
F 14
Approaching Zero Output Axis Select (900 With I/O Option Only)
140
F 16 Axis Reset Only 21
F 17 Mirror Image 135
F 18
Axis Coupling (900, 3-/4-Axis Only)
120
F 19
Axis Coupling (900, 4-Axis Only)
120
F 20 Parameter Settings 60
F 21 Beeper OFF/ ON 11
F 22 Display Dim OFF 71
F 23 Display Dim ON 71
To Next Page
Loading...
