80
Advanced (ADV) Functions Key (Continued)
Bolt-Hole Pattern Function (N/A for 900, Lathe
Mode)
The Bolt-Hole Pattern function allows you to program the X and Y positions for a
maximum of 10 different bolt-hole patterns (maximum 360 holes each) around the
circumference of a specified circle. The DRO can program the following types of bolt-
hole patterns:
q Partial Pattern In a partial pattern, the holes do not cover the entire circumference
of the circle. Instead they form an arc, called a partial pattern.
(See Figure 2)
q Full Pattern In a full pattern, the holes cover the entire circumference of the
circle. (See Figure 3)
Y
1.00 Inch
X0
Hole 1
Hole 3
90
o
-10
o
Beginning Angle:
-10
o
End Angle:
80
o
Holes:
3
X Center:
1.00 Inch (25.4 mm)
Y Center:
1.00 Inch (25.4 mm)
1.00 Inch
Hole 2
Figure 2: Partial Bolt-Hole Pattern
To Next Page
Loading...
