Anilam Wizard 900 - Contents

vi
Contents (Continued)
Selecting the Compensation Table, Entering an Axis Compensation ........................41
Key Functions for Compensation Table......................................................................44
Deleting a Compensation Value Table .......................................................................45
Axis Error Compensation ON/OFF .............................................................................46
Correction Factor OFF/ON – F 04 ........................................................................................47
Approaching Zero Indicator ..................................................................................................48
Approaching Zero – F 06......................................................................................................49
Approaching Zero Range – F 07 ..........................................................................................51
Approaching Zero Audio ON/OFF – F 08.............................................................................53
Connecting the Edge Sensor Probe.....................................................................................54
Edge Sensor Probe – F 09 ...................................................................................................55
Feedrate ON/OFF – F 26 .....................................................................................................57
Job Clock ON/OFF – F 34 ....................................................................................................58
Parameter Settings – F 20....................................................................................................60
Setting Up Encoder Parameters...........................................................................................60
Metric Linear Encoders.........................................................................................................62
Inch Linear Encoders (BT or JB Linear Encoders)...............................................................67
Rotary Encoders ...................................................................................................................68
Display Dim OFF/ON – F 22/ F 23 .......................................................................................72
Axis Designation – F 24........................................................................................................73
Select Language – F 99 .......................................................................................................74
Linear Encoder Error Detect OFF/ON – F 40/F 41...............................................................75
Diagnostics – F 45 ................................................................................................................76
Advanced (ADV) Functions Key ...........................................................................................78
Help Function..............................................................................................................78
Bolt-Hole Pattern Function (450 Only)........................................................................80
Partial Bolt-Hole Pattern .............................................................................................82
Full Bolt-Hole Pattern (450 Only)................................................................................86
Recalling Bolt-Hole Pattern Function (450 Only)........................................................90