Anilam Wizard 900 - Page 5

vii
Contents (Continued)
Linear-Hole/Frame-Hole Pattern Function (450 Only)................................................93
Recalling Linear-Hole/Frame-Hole Function (450 Only).............................................98
Taper Calculator Function (450L Only).....................................................................101
Datum Key (450 Only) ........................................................................................................103
Enter Datum..............................................................................................................103
Enter Datum (Alternate Method)...............................................................................106
Recall Datum ............................................................................................................108
Clear Datum – F 31...................................................................................................109
Tool Offset Key (450L Only) ...............................................................................................110
Enter Tool Offset.......................................................................................................110
Recall Tool Offset .....................................................................................................112
Modify Tool Offset – F 35 .........................................................................................113
Clear Tool Offset – F 32............................................................................................114
Axis Coupling (450L, 3-Axis Only) - F 18 ...........................................................................115
Output Connections (With I/O Option Only) .......................................................................116
Input Connections (With I/O Option Only) ..........................................................................117
Zero Output ON/OFF (With I/O Option Only) – F 33 .........................................................118
Approaching Zero Output Axis (With I/O Option Only) – F 14 ...........................................119
Zero Output Time Select (With I/O Option Only) – F 25.....................................................120
RS-232 Interface (With I/O Option Only)............................................................................121
RS-232 Setup (With I/O Option Only) – F 27 .....................................................................122
RS-232 ON/OFF (With I/O Option Only) – F 28 .................................................................125
Printing Axis Values (With I/O Option Only) .......................................................................126
Remote Operation (With I/O Option Only)..........................................................................127
Relay 1/Relay 2 Setup (With I/O Option Only) – F 38/F 39................................................128
Output Test (With I/O Option Only) – F 42 .........................................................................131
Constant Surface Speed (CSS) Setup (450L With CSS and I/O Options).........................132
DAC Output Voltage Setup (450L With CSS and I/O Options) – F 96 ..............................133
DAC Output Voltage Offset Adjustment (450L With CSS and I/O Options) – F 97 ..........135