Anilam Wizard 900 - Feedrate ON;OFF - F 26

57
Feedrate ON/OFF – F 26
F 26 allows you to display the maximum feedrate for all axes in the message window (if
feedrate is greater than 0.4 inches per minute or greater than 10 mm per minute). The
DRO displays the feedrate in inches per minute if set to INCH Mode and mm per minute
if set to MM Mode. If you move two or more axes at the same time, the DRO displays the
feedrate for the fastest moving axis. (Default: OFF)
To turn on the feedrate:
1. Press
The DRO displays the following in the message window:
Feed on
To turn off the feedrate:
1. Press
The DRO displays the following in the message window:
Feed off