Anilam Wizard 900 - Recalling Linear-Hole;Frame-Hole Function (450 Only)

98
Advanced (ADV) Functions Key (Continued)
Recalling Linear-Hole/Frame-Hole Function (N/A for 900, Lathe Mode)
The Recall Key (RCL) allows you to recall a maximum of 10 previously programmed
linear bolt–hole patterns.
To recall linear-hole pattern number 3 programmed in the previous section:
1. Press
ADV
repeatedly to scroll through
the Advanced Functions list.
When the DRO displays the following in the message window:
Lin
HOLE
2. Press
The DRO displays the following in the message window:
lHP NUMBER
To recall linear-hole pattern number 3 programmed in the previous section:
3. Press