Anilam Wizard 900 - Absolute Zero Set at Reference Mark - F 90

24
Absolute Zero Set at Reference Mark – F 90
F 90 allows you to reset one or more axes to zero at the reference mark. You must use
this feature when you use 100-point axis error compensation (F 80/F 81).
To reset all axes at the reference mark:
1. Press
The DRO resets all axis displays and displays the following in the message window:
marker
To reset one axis at the reference mark:
1. Press
2. Press the desired axis key.
3. Press
The DRO resets the specified axis display and displays the following in the message
window:
marker