Anilam Wizard 900 - Page 196

Index-6
recall
a dimension, 18
datum, 113
key, 90
last position, 30
program from external device –
F61, 150
tool offset, 117
ReCaLl key, 2
recalling
a bolt-hole pattern, 90
a linear-hole pattern, 98
a part zero position, 28
a preset dimension, 18
dimensions from the electronic
notepad, 129
reference indicator (RI), 25
referenced display, mode, 39
relay 1, 137, 169, 171, 173, 174,
176, 177
RELAY 1, 155
relay 1 setup – F 38, 152
relay 2, 137, 169, 171, 174, 176,
179, 180
RELAY 2, 155
relay 2 (spark-out/SparkArrest
TM
)
setup, 179, 180
relay 2 setup – F 39, 152
remote operation, 148
resetting
absolute zero, 18
an axis to zero, 20
parameters to factory settings, 70
resolution, 5
rotary encoder, 1, 60, 61, 67, 165
round spring clip, 54
RS-232
connection, 3
interface, 148
interface connector, pin
assignments, 142
ON/OFF – F 28, 146
setup – F 27, 143
RST symbol, 21, 22
S
scrolling, 15
select axis for recall – F 63, 134
select language – F 99, 73
selecting, direction of movement, 55
send program to external device –
F 60, 149
SET key, 2
setting
a correction factor – F 03, 37
a part zero - all axes, 26
a part zero - one axis, 25
display resolution (display degrees
in decimal mode), 68
display resolution (INCH mode), 64
display resolution (MM mode), 63
encoder resolution, 63, 66
EverTrack
TM
mode, 65
up encoder parameters, 60, 62
skew compensation, 78, 103
Spanish, 73
SPARK AUTO, 171, 175
spark cycle, 1
spark detection options, 171
spark erosion axis, 167
SPARK MAN, 171, 173
SPARK OFF, 172
spark out, 1
SparkArrest
TM
, 1, 167, 169, 171, 174,
176, 179, 180
SPARK-OFF, 171
spark-out, 167, 169, 171
spark-out cycle, 174, 176, 181