112
4.3.5 Sync signal polarity setting
For further details on the setting procedure, refer to “4.1.2 Setting the sync signals to ON or OFF and
setting the sync signal polarities.” The same settings are established for both the DVI analog and digital
signals.
4.3.6 EDID
For further details on the setting procedure, refer to “6.13.3 EDID.”
Note: The DDC_CLK frequency of DVI (channel 1) is fixed at 40 kHz. It does not exist in
DDC_CLK of Configuration. Also, the DDC_CLK frequency of DVI (channel 2) changes in
tandem with DDC_CLK of Configuration.
4.3.7 HDCP
For further details on the setting procedure, refer to “8.1 HDCP settings.”
4.3.8 DDC/CI
For further details on the setting procedure, refer to “6.13.4 DDC/CI.”
To Next Page
