AT&T PC 6300 - Page 448

MAINTENANCE
8. The list of installed hardware is displayed along with IS
LIST OF HARDWARE CORRECT? Press the y key
followed by the ENTER key.
9. Verified list of hardware is displayed along with
information on performing all tests or individual tests.
Select the Keyboard Test by pressing the 4 key followed by
the ENTER key.
10: PAUSE ON ERROR? is displayed. Press the y key followed
by the ENTER key.
TEST 400 - 83 KEYBOARD TEST
00:02:04 PASS '1
402 - 83 KEY KEYBOARD KEYBOARD SELFTEST ERROR
It'-
5-70
n
0
n
IS THERE A MOUSE CONNECTED? is displayed. Press
the n key if your system does not have a mouse. If your ^
system does have a mouse, press the y key (3.18 or later f j
versions of Diagnostics).
0
n
ft
11. The hardware associated with the keyboard is tested. As (1
the tests are running, verify that the LEDs on the Keyboard
blink. This is to verify that the LEDs are working properly.
If an error is found, a message similar to the following is
displayed:
0
D
D
n.
n
■'j.
n
A