Atlas Copco PowerMACS 4000 User Manual

Basic Functions
9836 3521 01 105
Enter the text to be printed at the top of the document in the field Header on top of page/Text. For the
ToolsTalk Printer you may also use the Bitmap combo box to select a bitmap to be displayed as header.
Enter the text to be printed at the bottom of the document in the field Footer at bottom of page/Text. For
the ToolsTalk Printer you may also use the Bitmap combo box to select a bitmap to be displayed as
footer.
To be able to include your own bitmap you must first place the bitmap in the directory named Bmp located
in the directory where you to install ToolsTalk PowerMACS.
Using the fields Characters to be sent to the Reporter BEFORE the main data and Characters to be
sent to the Reporter AFTER the main data you can specify character strings that will surround each
cycle data result printed.
Here you may also include non-printable characters. Typing their ASCII code in hexadecimal format
enclosed by a "<" and a ">" does this. Example: To frame each cycle data with a start-of-text character
(STX), before the data, and an end-of-text character (ETX), after the cycle data then enter:
 "<02>" in Characters to be sent to the Reporter BEFORE the main data
 "<03>" in Characters to be sent to the Reporter AFTER the main data
Settings for Fixed pos. layout are only shown when the Layout option is set to Fixed pos. The
parameter Report Bolts controls how many bolts, or actually bolt positions, to use when the bolt result
variables are laid out when formatting the bolt variables. Leaving it empty will cause the number of bolts of
the station producing the result to be used instead.

Atlas Copco PowerMACS 4000 Specifications

General

Brand	Atlas Copco
Model	PowerMACS 4000
Category	Power Tool
Language	English