EasyManuals Logo

Atlas Copco PowerMACS 4000 User Manual

Atlas Copco PowerMACS 4000
668 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #174 background imageLoading...
Page #174 background image
Set Up and Maintenance
174 9836 3521 01
4.13 Setup Problems
The Setup Problems function performs a number of tests on your setup. It will test all combinations of
programs against the bolt/spindles that you have setup using The Mode Table form. All target values will
be tested with respect to max values defined for the spindles used.
The window is by default docked on the left side of the ToolsTalk PowerMACS main window.
The list contains different categories. For each category a number of messages are displayed. Every
message is a classified as either an error or a warning.
If Show only errors is checked, only the messages classified as errors are displayed.
Note that the window is displayed even if the test succeeds. If so the text "No errors or warnings found" is
displayed.
You can configure the tests to be executed automatically when the setup is modified and/or when
connecting. This is controlled from the Set Up Options form.
If the checkbox Perform Setup problem detection when setup changes on the Set Up Options form is
not checked then setup problems will change appearance whenever the setup is changed to indicate that
the last test is no longer valid.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Atlas Copco PowerMACS 4000 and is the answer not in the manual?

Atlas Copco PowerMACS 4000 Specifications

General IconGeneral
BrandAtlas Copco
ModelPowerMACS 4000
CategoryPower Tool
LanguageEnglish

Related product manuals