Set Up and Maintenance
9836 3521 01 173
Customer error codes can also be specified for the two cases when the cycle ends without any error bit
set, that is, when the cycle ends with status OK, OKR or NOKRM (see chapter: Result variables -
Statuses for a description of statuses). Use Code to use when cycle ends OK or OKR and Code to use
when cycle ends NOKRM to specify these respectively.
To always be able to determine if the cycle ended OK or not a value must be specified for the OK/OKR
case if any error bit has a blank customer specific error code.
Note! Code to use when cycle ends NOKRM will be set to the default code used for NOKRM (NRM if
the English language file is used) when a setup created with a WinTC version earlier than 5.1.0 is
loaded and its Code to use when cycle ends OK is empty.
To Next Page
Loading...
