Tightening
268 9836 3521 01
6.5.1 Program Properties
A tightening program has a number of general properties, the are shown in the Details window when the
Program Settings box is selected.
6.5.1.1 Program Common properties
The most basic settings for a program are located in the Common group.
ï‚· Pgm No.: A tightening program is identified by its name. However, using this property you may
optionally specify a Program number as an alternative identifier. This number can be used for
reporting and is mandatory when program from PLC is used, as the PLC configures which program
to run using the Pgm. No.
ï‚· Program Name: The name of the program.
ï‚· Comment: Any comment about the program.
6.5.1.2 Program User variables
This group contains the defined user variables for a program.
ï‚· Name: The name of the variable.
ï‚· Description: Variable description.
ï‚· Value: The value of the variable when the program is run.
ï‚· Unit: The unit of the variable (for information only).
User Variables are used to make programs more flexible and more easy to manage. If a user variable is
defined in the program you can later refer to that variable when entering parameters for a step, check,
restriction instead of hardcoding actual values.