EasyManua.ls Logo

Atlas Copco PowerMACS 4000

Atlas Copco PowerMACS 4000
668 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Set Up and Maintenance
9836 3521 01 149
4.6.4 Angle Channels page
The Angle Channels page contain information about the equipped angle channels. It is also possible to
configure the double transducer check here.
This page shows basic properties for each equipped angle channel, it is possible to Disable the
secondary Angle channel (if equipped).
4.6.4.1 Angle Double Transducer Check
It is possible to configure a default double transducer check to run during cycles if two angle channels are
equipped on the spindle.

Table of Contents

Related product manuals