Peripheral Devices
9836 3521 01 453
8.11.3 FSH
FSH is a protocol specified by General Motors used to communicate between the PowerMACS and the
Fastening System Host (FSH)
Specify in IP address the TCP/IP address of the Fastening system Host (FSH).
Specify in Port No which port to use in the FSH. (default is 4242)
The Station No is the identification of the TC in the FSH, this is sent in all telegrams and identifies the
source of all telegrams.
In the following text the server is described as FSH (Fastening system Host) and the PowerMACS as TC
(Torque controller),
The protocol is implemented according to the General Motors document "GAE Electric Nutrunner
Controller Design Criteria", GAEc-03 6-9-03Revision.doc.
To Next Page
Loading...
