PLC
9836 3521 01 255
To set inputs do the following:
1. Enter the new values for one or more of the inputs. A checked check box corresponds to True, an
unchecked to False.
2. Press the button Set. This cause the new values to be sent to the PLC.
Note! The set values will remain in the PLC until next time they are changed, or the PLC is restarted.
Closing the PLC Console window will not clear any values.
If you, as an example, connect "Cons In 1" to the PLC output START then you can simulate the external
start signal that normally is input via some external device. Below the currently selected mode, which is
set using digital inputs in this case, is also displayed as the "Cons Out 1" variable.
To Next Page
Loading...
Need help?
General
