Tightening
354 9836 3521 01
According to First failure settings
According to First failure settings
According to Fatal failure settings
According to First failure settings
According to First failure settings
According to Fatal failure settings
Bolts that never reach a CE step, for example due to that it is terminated, will use the Monitoring checks
defined on the CE step it would have reached if the execution should have continued normally. As an
example of this see the program outlined below. If the bolt is ordered to terminate in step 2 the Monitoring
settings of the first CE step (step 8) will be used. If terminated at step 10 the settings of the second CE
step (step 12) is used.
Failing
synchronization
interval