Peripheral Devices
420 9836 3521 01
Select the correct MAC Id for the Indicator Box. Select the correct Indicator box software version.
Software versions up to 0.12 have a configuration in the Indicator box which specifies ten lamps to be
used. Later software versions allow the user do decide exactly which of the lamps should have a specific
function.
Configure the Indicator Box by selecting the component you wish to edit (lamp or digital input) in the
property grid on the right side or by clicking on the component in the indicator box image or LED signal
list.
Once a component is selected configure the digital IO signal to connect to the component and additional
properties (flashing, duration etc.).
When connected to a system the form will show show the signal values in realtime.
To Next Page
Loading...
