Peripheral Devices
9836 3521 01 441
In chapters below is described how to configure the different Ethernet protocol devices. The protocols are
standard protocols, which are defined by major car manufacturers. It is also described what functions are
included and how they are mapped on PowerMACS functions.
The Ethernet protocol device does not require any additional hardware to be connected to the TC since it
uses the TCs standard Ethernet connector. However, you must make sure that the network between your
PowerMACS system and the Ethernet server is correctly configured. See PowerMACS Ethernet Manual
[3] for how to do this.
To Next Page
Loading...
Need help?
General
