Peripheral Devices
446 9836 3521 01
Implementation description
Vehicle Id Number download request
Selection of Wp Id. Wp Id is sent to PLC and
CurrentIdString is updated the CurrentIdString is also
reported to the station, which reports the Id to ephan device.
When TestBolt is run Id is reset to the prior value after the
cycle.
Vehicle Id Number upload subscribe
Vehicle Id Number upload acknowledge
Vehicle Id Number upload unsubscribe
Events mapped on 3-digit numbers. All events for the station
and all general events are reported.
There is no Controller ready status and Tool ready status
available in the PowerMACS events. Status is always
reported as OK.
Alarm Acknowledged on torque
controller
Acknowledges all events in PM regardless of specified error
number.
TC sends this message when an event (subscribed on) has
been marked observed in PM. If command "mark all as
observed" is used event code 0 is reported.
Alarm status reports the oldest not already reported event.
After alarm status Alarm Upload is done automatically until
there are no not reported events in the queue. Alarm status
1 if any not observed events exist.
Set Time in the Torque Controller
Only possible to perform on devices on the System TC.
Multi spindle status subscribe
Multi spindle status upload
See TC Status Record Formats for message structure.
Multi spindle status upload acknowledge
Multi spindle status unsubscribe
Multi spindle result subscribe
Multi spindle result upload
See TC Result Record Formats for message structure.
Multi spindle result upload acknowledge
Multi spindle result unsubscribe
To Next Page
Loading...
