Peripheral Devices
460 9836 3521 01
If the connection to the PLUS server is broken when the cycle is finished the data will be sent when the
connection is established again.
If unchecked the sending of data is controlled by the PLC variable PLUS_DOKUENABLE instead.
Conversion table -Converts the received TMUs to a mode number. Has the same functionality as the
conversion tables used for the Stations Work piece identifier and Multiple identifiers functions.
FP table -The value to use as FP, “Fertigungspunkt” when sending cycle data to PLUS is dependent on
the mode used for the tightening. The FP to use are specified in this table with one row for each mode. If
no values are specified for a mode, cycle data produced when running this mode will not be sent to the
PLUS server.
The values specified will also be included in the cycle data as the result variables Station QO
Strings entered in the columns US if ok, US if OKR and US if NOK for a specific mode are used in the
cycle data US field. US is part of the bolt data. US is selected according the the table below.
If no string is entered the result variable Id Res 4 is used. If Id Res 4 is also empty eight zeros are sent
(i.e. 00000000)
Test PLUS - When this button is pressed the connection to the PLUS server is tested. The result of the
test will be indicated as OK or NOK. The test button is only available if the advanced form is opened
connected to the target system.
To Next Page
Loading...
Need help?
General
