Appendix
626 9836 3521 01
Bolt %d is connected to invalid spindle %d
ST: signal from undefined spindle
ST: signal from undefined bolt
ST: Data structures inconsistent
ST: Telegram %d received in wrong state %d from proc %d
Start is impossible since station has no contact with spindle %d
Start is impossible since station has no contact with PLC
Start is impossible since station has no contact with Test Bolts
Unexpected Cycle End when running RM
Invalid Bolt number from spindle
ST: DB read error %d for bolt %d
Start is impossible since stations has no contact with syinit
Cycle data too big, bolt %d not stored
Start is impossible since bolt %d and %d both uses TC %d
Station failed to reach TC. Bolt is disconnected (OK)
Station failed to reach TC. Bolt is disconnected (NOK)
Station starts the cycle even though %d spindles could not be
reached
Station failed to init servo. Bolt is disconnected (OK)
Station failed to init servo. Bolt is disconnected (NOK)
Station failed to read which cycle data that is wanted
Start is impossible since there are conflicting TCs in the station
Cycle data dropped since no bolt reached report threshold
torque limit
ST: BoltControl from PLC has bad value (%d) in mode %d
ST: Found no program for mode %d in mode table to run for the
bolt
Start is impossible since station has no contact with Station
service
PLC BOLTCTRL2 cmd %d ignored since no bolts are selected
PLC BOLTCTRL2 cmd %d ignored since station is not idle
PLC BOLTCTRL2 cmd %d ignored since there is no cycle data
To Next Page
Loading...
