Atlas Copco SMARTROC D65 TIER 4 FINAL User Manual

SmartROC D65 Tier 4 Final 7 Feeder
142
7.1.1 Feeder chain tension
tension, feeder chain
Tighten or loosen the feeder chain with the bolts (1).
If it is necessary to change the tension of the feeder chain, lubricate the bolts (1) via the
grease nipples (2) before starting to adjust. A small amount of grease should also be ap-
plied directly to the threads at the same time.
The distance (A) must be at least 280 mm.
7.2 Tension of hoses on the hose drum
1.
Move the rotation unit halfway down on the feeder.
2.
Fit a chain pulley block between the hose drum cradle and the top of the feeder.
3.
Remove the cover plate on the hose drum cradle that holds the chain in place on the
sprocket wheel.
4.
Lift up the chain from the sprocket wheel using a crowbar or similar.
5.
Pull the hose drum cradle along the feeder with the chain pulley block until the hoses
are tensioned.
6.
Remove the crowbar, refit the cover plate and remove the chain pulley block.

Atlas Copco SMARTROC D65 TIER 4 FINAL Specifications

General

Brand	Atlas Copco
Model	SMARTROC D65 TIER 4 FINAL
Category	Industrial Equipment
Language	English