SmartROC D65 Tier 4 Final 7 Feeder
146
7.7 Sealing disc
Sealing disc (1)
Cuttings accumulate over time behind the sealing disc (1). There is risk that the cuttings
may damage the chain and gears. Bend the cutting disc down in order to clean out dirt col-
lected behind it.
7.8 Replacing the slide pieces in the holder
Each holder has replaceable slide pieces. The slide piece (C) is kept in place by three keys
(D). The slide pieces must be replaced at regular intervals so that the steel in the holder
does not wear against the beam. Replace if there is less than 1 mm of wear allowance on
the slide piece. It is a good idea to change all the slide pieces at the same time, even if
some of them are slightly thicker.
Replacing slide pieces
To Next Page
Loading...
Need help?
General
