Name: Atlas Copco SMARTROC D65 TIER 4 FINAL
Brand: Atlas Copco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

SmartROC D65 Tier 4 Final 9 Dust collector (DCT)

155

9 Dust collector (DCT)

9.1 Filter test, dust collector (DCT)

Measurement points for dust collector filter

For checking filters in dust collector. Unscrew plugs (a) and apply a differential pressure

gauge to the two holes.

Measure the pressure drop while air flushing is activated. If the drop is greater than an 800

mm (wg) column of water, all the filters should be replaced.

NOTE: If pump 3 does not maintain preset pressure it may be due to the dust collector

filter being clogged.

NOTE: If the dust collector is operated with a deficient filter then the fan wings are

worn.

Questions and Answers:

Need help?

Do you have a question about the Atlas Copco SMARTROC D65 TIER 4 FINAL and is the answer not in the manual?

Atlas Copco SMARTROC D65 TIER 4 FINAL Specifications

General