Atlas Copco SMARTROC D65 TIER 4 FINAL - System - Administration

SmartROC D65 Tier 4 Final 5 RCS drilling system
73
5.5.5 System - administration
Administration
In this menu, you can save drill parameters for later retrieval in case of fault finding or up-
grading of existing software to a later version. The information is saved on a USB memory
stick.
!
NOTE: Only use USB memory sticks from Atlas Copco.
Save parameters: Parameters are saved on a USB memory stick.
Load parameters: Parameters are retrieved from a USB memory stick.
!
NOTE: For all reprogramming, first make sure that all the parameters are saved on a
USB memory stick so they can be downloaded into the new version of the software
later.