SmartROC D65 Tier 4 Final 5 RCS drilling system
76
4.
Remove the USB memory stick and switch off the RCS system again.
5.
Restart the RCS system.
6.
If you want to use the same settings as previously and they are saved on a USB
memory stick, they can now be loaded into the system. See the section Saving and
loading parameters.
!
NOTE: Only use USB memory sticks from Atlas Copco.
Date and time
The date and time may have to be set on a new rig or if new software has been loaded.
Many settings are made by changing an existing numerical value, e.g. setting the date and
time in the Administration menu.
Date and time in the Administration menu
1.
Move the cursor to the current numerical value using the arrow keys. The entire value
will be highlighted.
2.
Press the enter button. One individual number will now be highlighted in another col-
our.
3.
Increase the value with the up-arrow key and lower the value with the down-arrow
key.
4.
Complete by pressing Enter.
In certain cases the numerical value may have several digits. In such cases, change one
digit at a time. Use the left and right arrow keys to move the cursor to the desired digit
(ones, tens, etc.).
To Next Page
Loading...
Need help?
General
