AudioCodes Mediant 800 Reference Guide

CHAPTER7 SNMP Traps
Mediant 800 SBC | SNMP Reference Guide
Alarm acHASystemFaultAlarm
Critical HA feature has
failed to initialize
due to some
configuration
error.
"SYS_HA: HA
Remote address
not configured,
No HA system."
Need to configure a valid
'HA Remote Address'.
"SYS_HA: HA
Remote address
and
Maintenance IF
address are not
on the same
subnet, No HA
system."
Need to configure a valid
Maintenance network
interface and 'HA Remote
Address'.
"SYS_HA: HA
Remote address
and
Maintenance IF
address should
be different, No
HA system."
Need to configure a valid
Maintenance network
interface and 'HA Remote
Address'.
HA feature is
active, but the
system is not
operating in HA
mode.
"Switch-Over:
Reason = Fatal
exception error"
HA was lost due to
switchover and should
return automatically after a
few minutes. Corrective
action is not required.
"Switch-Over:
Reason = SW
WD exception
error"
HA was lost due to
switchover and should
return automatically after a
few minutes. Corrective
action is not required.
"Switch-Over:
Reason = System
error"
HA was lost due to
switchover caused by a
general system error and
should return automatically
after a few minutes.
Corrective action is not
required.
"Switch-Over:
Reason = Eth link
HA was lost due to
switchover. Reconnect the
- 106 -

AudioCodes Mediant 800 Specifications

General

Protocols	SIP, H.323
Digital Interfaces	1/2 E1/T1 PRI
Management	Web, CLI, SNMP
Mounting	19-inch rack
Codecs	G.711, G.729, G.722, G.723.1
Power Supply	100-240V AC
Operating Temperature	0 to 40°C
Storage Temperature	-25 to 70°C
Humidity	10% to 90% non-condensing