AudioCodes Mediant 800 Reference Guide

CHAPTER7 SNMP Traps
Mediant 800 SBC | SNMP Reference Guide
Alarm acOperationalStateChange
state of the node is
disabled if the device fails
to properly initialize.
■ Look for other alarms and
Syslogs that might provide
additional information
about the error.
Cleared Operational
state changed
to enabled
- -
Remote Monitoring Alarm
Table 7-26: acRemoteMonitoringAlarm
Alarm acRemoteMonitoringAlarm
OID 1.3.6.1.4.1.5003.9.10.1.21.2.0.145
Description The alarm is sent when the device loses connection with the remote
monitoring server (configured on the device as a Remote Web Service) for
remote monitoring of the device when it is located behind a NAT.
Default
Severity
Warning
Source
Varbind
Text
Board#1
Event Type communicationsAlarm
Probable
Cause
callEstablishmentError
Alarm
Severity
Condition Text Corrective Action
Warning The device receives an HTTP
failure response
(4xx/5xx/6xx) when it sends
the monitoring report.
"No connection
with Remote
Monitoring server"
Check that the
configuration of the
Remote Web
Service is correct.
Cleared The device receives an HTTP - -
- 126 -

AudioCodes Mediant 800 Specifications

General

Protocols	SIP, H.323
Digital Interfaces	1/2 E1/T1 PRI
Management	Web, CLI, SNMP
Mounting	19-inch rack
Codecs	G.711, G.729, G.722, G.723.1
Power Supply	100-240V AC
Operating Temperature	0 to 40°C
Storage Temperature	-25 to 70°C
Humidity	10% to 90% non-condensing