AudioCodes Mediant 800 - Analog Port Ground Fault Out-Of-Service Alarm

CHAPTER7 SNMP Traps
Mediant 800 SBC | SNMP Reference Guide
Alarm acAnalogPortHighTemperature
automatically
disconnected.
down the analog
port and tries to
activate it again
later when the
device's
temperature
drops.
Cleared Temperature is
back to normal -
analog port is back
in service.
- -
Analog Port Ground Fault Out-of-Service Alarm
The alarm is applicable only to FXS interfaces.
Table 7-48: acAnalogPortGroundFaultOutOfService
Alarm acAnalogPortGroundFaultOutOfService
OID 1.3.6.1.4.1.5003.9.10.1.21.2.0.76
Default
Severity
Major / Clear
Source
Varbind Text
System#0/analogports#<n>, where n is the port number
Event Type physicalViolation
Probable
Cause
equipmentMalfunction (this alarm is sent when the FXS port is inactive
due to a ground fault)
Alarm Text Analog Port Ground Fault Out Of Service
Corrective
Action
■ No corrective action is required.
■ The device shuts down the port and tries to activate it again when
the relevant alarm is over.
- 151 -