AudioCodes Mediant 800 - Performance Monitoring Mibs for IP Network Interfaces

CHAPTER6 Performance Monitoring
Mediant 800 SBC | SNMP Reference Guide
The tables in this section use check marks "√" and crosses "x" to indicate support for
the specific MIB property:
● "G/C": gauge / counter
● "Int": measured interval
● "Val": value of gauge or counter
● "Min": minimum gauge value
● "Max": maximum gauge value
● "Avg": average within the interval
● "TbLT": percentage of interval time that value was below low threshold
● "TbT": percentage of interval time that value was between low and high thresholds
● "TaHT": percentage of interval time that value was above high threshold
● "HT": configured or default high threshold
● "LT": configured or default low threshold
Performance Monitoring MIBs for IP Network Interfaces
The following table lists the performance monitoring MIBs for IP network interfaces.
Table 6-1: Performance Monitoring MIBs for IP Network Interface
Performance Monitoring MIB
G
/
C
I
n
t
V
a
l
M
in
M
ax
A
v
g
Tb
LT
T
b
T
Ta
HT
H
T
L
T
■ MIB Name: acPMNetUtilKBytesTable
■ OID: 1.3.6.1.4.1.5003.10.11.2.31.1
■ Source Name: PM_NetUtilKBytes
Indicates the number of Kbytes
(1000 bytes) received and
transmitted on the interface (Index
0 is transmit; Index 1 is receive),
including those received in error,
from the beginning of the current
collection interval as indicated by
the time interval.
OVOC parameter name: Number of
Incoming / Outgoing Kbytes
■ High threshold:
acPMNetUtilsAttributesKBytesH
ighThreshold
(1.3.6.1.4.1.5003.10.11.1.33.1)
■ Low threshold:
acPMNetUtilsAttributesKBytesL
G 1
5
ü ü ü ü ü ü ü û û
- 33 -