AudioCodes Mediant 800 - Page 21

CHAPTER2 SNMP Overview
Mediant 800 SBC | SNMP Reference Guide
Parameter Description Default
SNMPUsers_
AuthProtocol
Authentication protocol to be used for this user.
Possible values are 0 (none), 1 (MD5), 2 (SHA-1)
0
SNMPUsers_
PrivProtocol
Privacy protocol to be used for this user. Possible
values are 0 (none), 1 (DES), 2 (3DES), 3 (AES128), 4
(AES192), 5 (AES256)
0
SNMPUsers_AuthKey Authentication key. ""
SNMPUsers_PrivKey Privacy key. ""
SNMPUsers_Group The group that this user is associated with. Possible
values are 0 (read-only group), 1 (read-write group),
and 2 (trap group). The actual group will be
ReadGroup<sl>, ReadWriteGroup<sl> or
TrapGroup<sl> where <sl> is the SecurityLevel
(1=noAuthNoPriv, 2=authNoPriv, 3=authPriv)
0
Keys can be entered in the form of a text password or in the form of a localized key in hex
format. If using a text password, then it should be at least 8 characters in length. Below is an
example showing the format of a localized key:
26:60:d8:7d:0d:4a:d6:8c:02:73:dd:22:96:a2:69:df
The following sample configuration creates three SNMPv3 USM users.
[ SNMPUsers ]
FORMAT SNMPUsers_Index = SNMPUsers_Username, SNMPUsers_
AuthProtocol, SNMPUsers_PrivProtocol, SNMPUsers_AuthKey, SNMPUsers_
PrivKey, SNMPUsers_Group;
SNMPUsers 0 = v3user, 0, 0, -, -, 0;
SNMPUsers 1 = v3admin1, 1, 0, myauthkey, -, 1;
SNMPUsers 2 = v3admin2, 2, 1, myauthkey, myprivkey, 1;
[ \SNMPUsers ]
The example above creates three SNMPv3 users:
■ The user v3user is set up for a security level of noAuthNoPriv(1) and is associated with
ReadGroup1.
■ The user v3admin1 is setup for a security level of authNoPriv(2), with authentication
protocol MD5. The authentication text password is “myauthkey” and the user is
associated with ReadWriteGroup2.
- 12 -