AudioCodes Mediant 800 - Page 28

CHAPTER2 SNMP Overview
Mediant 800 SBC | SNMP Reference Guide
name of the SNMPv3 that this user is associated with.
2. If a row does not already exist for this combination of user and SecurityLevel, add a row to
the snmpTargetParamsTable with these values: Name=usm<user>, MPModel=3(SNMPv3),
SecurityModel=3 (usm), SecurityName=<user>, SecurityLevel=M, where M is either 1
(noAuthNoPriv), 2(authNoPriv) or 3(authPriv).
All changes to the trap destination configuration take effect immediately.
➢ To delete a trap destination:
■ Remove the appropriate row from the snmpTargetAddrTable.
■ If this is the last trap destination associated with this user and security level, you could
also delete the appropriate row from the snmpTargetParamsTable.
➢ To modify a trap destination:
You can change the IP address and or port number for an existing trap destination. The same
effect can be achieved by removing a row and adding a new row.
■ Modify the IP address and/or port number for the appropriate row in the
snmpTargetAddrTable.
➢ To disable a trap destination:
■ Change TagList on the appropriate row in the snmpTargetAddrTable to the empty string.
➢ To enable a trap destination:
■ Change TagList on the appropriate row in the snmpTargetAddrTable to ‘AC_TRAP’.
■ Change TagList on the appropriate row in the snmpTargetAddrTable to "AC_TRAP".
- 19 -