CHAPTER6 Performance Monitoring
Mediant 800 SBC | SNMP Reference Guide
Performance Monitoring MIB
G
/
C
I
n
t
V
a
l
M
i
n
M
a
x
A
v
g
T
b
L
T
T
b
T
T
a
H
T
H
T
L
T
concurrently busy, if this scenario occurs.
For example, if trunk group #3 has 200
channels and all these were concurrently
busy for 60 seconds, then this MIB will
display 60 for this trunk group. Note that
trunks that are out of service or not
configured (set to NONE) are considered
"busy" in this calculation.
■ MIB Name: acPMSIPTrunkGroupAllTrunksBusyPercentageTable
■ OID: 1.3.6.1.4.1.5003.10.8.2.52.40
■ Source Name: PM_gwTrunkGroupAllTrunksBusyPercentage
Indicates the percentage (%) of time
within a 15-minute polling interval, that all
channels in a specific trunk group were
busy simultaneously. This measurement
is sent only at the end of the interval
(beginning of the current interval), so
each measurement reflects the previous
interval. For example, assume that all
trunks of a trunk group were busy for 6
minutes during an interval. The MIB will
send a measurement of 40% (i.e., 6
minutes / 15 minutes * 100). In other
words, all trunks of the trunk group were
simultaneously busy for 40% of the time
during this 15-minute interval.
■ High threshold:
acPMSipAttributesTrunkGroupAllTrun
ksBusyPercentageHighThreshold
(1.3.6.1.4.1.5003.10.8.1.34.33)
■ Low threshold:
acPMSipAttributesTrunkGroupAllTrun
ksBusyPercentageLowThreshold
(1.3.6.1.4.1.5003.10.8.1.34.34)
G 1
5
ü û û û û û û
0 0
■ MIB Name: acPMTrunkUtilizationTable
- 61 -
To Next Page
Loading...
Need help?
General
