Version 5.8 251 September 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
[acUserInputAlarmDescription]
Defines the description of the input alarm.
[acUserInputAlarmSeverity]
Defines the severity of the input alarm.
[AlarmHistoryTableMaxSize]
Determines the maximum number of rows in the Alarm
History table. This parameter can be controlled by the
Config Global Entry Limit MIB (located in the Notification
Log MIB).
The valid range is 50 to 100. The default value is 100.
Note: For this parameter to take effect, a device reset is
required.
SNMP Trap Destination Parameters
Note: Up to five SNMP trap managers can be defined.
SNMP Manager
[SNMPManagerIsUsed_x]
Determines the validity of the parameters (IP address and
port number) of the corresponding SNMP Manager used
to receive SNMP traps.
[0] (Check box cleared) = Disabled (default)
[1] (Check box selected) = Enabled
Web: IP Address
EMS: Address
[SNMPManagerTableIP_x]
Defines the IP address of the remote host used as an
SNMP Manager. The device sends SNMP traps to this IP
address.
Enter the IP address in dotted-decimal notation, e.g.,
108.10.1.255.
Web: Trap Port
EMS: Port
[SNMPManagerTrapPort_x]
Defines the port number of the remote SNMP Manager.
The device sends SNMP traps to this port.
The valid SNMP trap port range is 100 to 4000. The
default port is 162.
Trap Enable
[SNMPManagerTrapSendingEnable_x]
Activates or de-activates the sending of traps to the
corresponding SNMP Manager.
[0] Disable = Sending is disabled.
[1] Enable = Sending is enabled (default).
[SNMPManagerTrapUser_x]
This parameter can be set to the name of any configured
SNMPV3 user to associate with this trap destination. This
determines the trap format, authentication level, and
encryption level. By default, the trap is associated with the
SNMP trap community string.
Trap Manager Host Name
[SNMPTrapManagerHostName]
Defines an FQDN of a remote host that is used as an
SNMP manager. The resolved IP address replaces the
last entry in the Trap Manager table (defined by the
parameter SNMPManagerTableIP_x) and the last trap
manager entry of snmpTargetAddrTable in the
snmpTargetMIB.
For example: 'mngr.corp.mycompany.com'.
The valid range is a 99-character string.
To Next Page
Loading...
