AudioCodes MP-124 User Manual

Version 5.8 325 September 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
Notes:
 This parameter is applicable to FXO and FXS interfaces,
but for FXO the Web interface does not display this
parameter.
 It is possible to configure whether the KeyBlindTransfer
code is added as a prefix to the dialed destination number,
by using the parameter KeyBlindTransferAddPrefix (refer to
''Channel Parameters'' on page 344).
Keypad Feature - Call Waiting Parameters
Activate
[KeyCallWaiting]
Keypad sequence that activates the Call Waiting option. After
the sequence is pressed, a confirmation tone is heard.
Deactivate
[KeyCallWaitingDeact]
Keypad sequence that deactivates the Call Waiting option.
After the sequence is pressed, a confirmation tone is heard.
Keypad Feature - Reject Anonymous Call Parameters
Activate
[KeyRejectAnonymousCall]
Keypad sequence that activates the reject anonymous call
option, whereby the device rejects incoming anonymous calls.
After the sequence is pressed, a confirmation tone is heard.
Deactivate
[KeyRejectAnonymousCallDeact]
Keypad sequence that de-activates the reject anonymous call
option. After the sequence is pressed, a confirmation tone is
heard.
[RejectAnonymousCallPerPort]
This ini file table parameter determines whether the device
rejects incoming anonymous calls on FXS interfaces. The
format of this parameter is as follows:
[RejectAnonymousCallPerPort]
FORMAT RejectAnonymousCallPerPort_Index =
RejectAnonymousCallPerPort_Enable;
[\RejectAnonymousCallPerPort]
Where,
 Enable = accept [0] (default) or reject [1] incoming
anonymous calls.
For example:
[RejectAnonymousCallPerPort]
RejectAnonymousCallPerPort 0 = 0;
RejectAnonymousCallPerPort 1 = 1;
[\RejectAnonymousCallPerPort]
If enabled, when a device's FXS interface receives an
anonymous call, it responds with a 433 (Anonymity Disallowed)
SIP response.
Notes:
 This parameter is applicable only to FXS interfaces.
 This parameter is per device.
 This parameter can appear up to 8 times for 8-port MP-11x
devices and up to 24 times for MP-124 devices.
 The double dollar ($$) symbol represents the default value.
 For an explanation on using ini file table parameters, refer
to ''Format of ini File Table Parameters'' on page 191.

AudioCodes MP-124 Specifications

General

Model	MP-124
Category	Gateway
Analog Ports	24 FXS
Ethernet Ports	2
Protocol Support	SIP, H.323
Fax Support	T.38, G.711 pass-through
Power Supply	100-240VAC, 50-60Hz
Operating Temperature	0°C to 40°C
Voice Codecs	G.711, G.729, G.723.1, G.726
Management	SNMP
Storage Temperature	-20°C to 70°C
Humidity	10% to 90%, non-condensing
Network Interface	10/100Base-T Ethernet