EasyManuals Logo

AudioCodes MP-124 User Manual

AudioCodes MP-124
486 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #329 background imageLoading...
Page #329 background image
Version 5.8 329 September 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
For a description of ini file table parameters, refer to ''Format
of ini File Table Parameters'' on page 191.
Hunt Group Settings Table
[TrunkGroupSettings]
This ini file table parameter defines rules for port allocation per
Hunt Group. If no rule exists, the global rule defined by the
parameter ChannelSelectMode takes effect. The format of this
parameter is as follows:
[TrunkGroupSettings]
FORMAT TrunkGroupSettings_Index =
TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode,
TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName,TrunkGroupSettings_Cont
actUser, TrunkGroupSettings_ServingIPGroup;
[\TrunkGroupSettings]
For example:
[TrunkGroupSettings]
TrunkGroupSettings 0 = 1, 0, 5, audiocodes, user, 1;
TrunkGroupSettings 1 = 2, 1, 0, localname, user1, 2;
[\TrunkGroupSettings]
Notes:
This parameter can include up to 24 indices.
For configuring Hunt Group Settings using the Web interface,
refer to ''Configuring Trunk Group Settings'' on page 150.
For a description on using ini file table parameters, refer to
''Format of ini File Table Parameters'' on page 191.
Web: Channel Select Mode
EMS: Channel Selection Mode
[ChannelSelectMode]
Port (channel) allocation algorithm for IP-to-Tel calls.
[0] By Dest Phone Number = Selects the device's channel
according to the called number (defined in the 'Endpoint
Phone Number' table -- Configuring the Endpoint Phone
Numbers on page 149). (d
efault.)
[1] Cyclic Ascending = Selects the next available channel in
an ascending cyclic order. Always selects the next higher
channel number in the hunt group. When the device reaches
the highest channel number in the hunt group, it selects the
lowest channel number in the hunt group and then starts
ascending again.
[2] Ascending = Selects the lowest available channel. It
always starts at the lowest channel number in the hunt group
and if that channel is not available, selects the next higher
channel.
[3] Cyclic Descending = Selects the next available channel in
descending cyclic order. Always selects the next lower
channel number in the hunt group. When the device reaches
the lowest channel number in the hunt group, it selects the
highest channel number in the hunt group and then starts
descending again.
[4] Descending = Selects the highest available channel.
Always starts at the highest channel number in the hunt
group and if that channel is not available, selects the next

Table of Contents

Other manuals for AudioCodes MP-124

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes MP-124 and is the answer not in the manual?

AudioCodes MP-124 Specifications

General IconGeneral
ModelMP-124
CategoryGateway
Analog Ports24 FXS
Ethernet Ports2
Protocol SupportSIP, H.323
Fax SupportT.38, G.711 pass-through
Power Supply100-240VAC, 50-60Hz
Operating Temperature0°C to 40°C
Voice CodecsG.711, G.729, G.723.1, G.726
ManagementSNMP
Storage Temperature-20°C to 70°C
Humidity10% to 90%, non-condensing
Network Interface10/100Base-T Ethernet

Related product manuals