SIP User's Manual 442 Document #: LTRT-65412
MP-11x & MP-124
Figure 9-18: Configuring Endpoint
5. In the 'Hunt Group Settings' page (refer to ''Configuring the Trunk Group Settings'' on
page 150), configure 'Per
Account' registration for Hunt Group ID #1 and associate it
with IP Group #1; Configure 'Per Endpoint' registration for Hunt Group ID #2 and
associated it with IP Group #2.
Figure 9-19: Configuring Hunt Groups
6. In the 'Authentication' page (refer to “Configuring Authentication” on page 142), fo
r
channels 5-8 (i.e., Hunt Group ID #2), define for each channel the registration
(authentication) user name and password.
Figure 9-20: Configuring Username and Password for Channels 5-8 in Authentication Page
7. In the 'Account Table' page (refer to ''Configuring the Account Table'' on page 102),
configure a single Account for Hunt Group ID #1, including an authentication user
name and password, and enable registration for this Account to ITSP 1 (i.e., Serving
IP Group is 1).
Figure 9-21: Configuring Accounts
8. In the 'IP to Hunt Group Routing' page (refer to ''Configuring the IP to Trunk Group
Routing'' on page 135), configure that
INVITEs with "ITSP1" as the hostname in the
From URI are routed to Hunt Group #1, and INVITEs with "ITSP2" as the hostname in
the From URI are routed to Hunt Group #2. In addition, configure calls received from
ITSP1 as associated with IP Group #1.
To Next Page
Loading...
