AutomationDirect DL205 - Page 493

DL205 User Manual, 4th Edition, Rev. D
5-269
Chapter 5: Standard RLL Instructions
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
Sum Binary Numbers (SUMBIN) (IB-502)
Sum Binary Numbers sums up a list of consecutive 16-bit WORD Binary numbers into a
32-bit DWORD binary result.
You specify the group’s starting and ending V-memory addresses (inclusive). When enabled,
this instruction will add all the numbers in the group (so you may want to place a differential
contact driving the enable).
SUMBIN could be used as the first part of calculating an average.
SUMBIN Parameters
• Start Address: specifies the starting address
of a block of V-memory location values to
be added together (Binary)
• End Addr (inclusive): specifies the ending
address of a block of V-memory location
values to be added together (Binary)
• Result (DWORD Binary): specifies the
location where the sum of the block of
V-memory binary values will be placed
SUMBIN Example
In the following example, the SUMBIN instruction is used to total the sum of all Binary values
in words V2000 thru V2007 and store the resulting 8-digit double word Binary value in V3000
and V3001 when C100 turns on.
DS5 Used
HPP
N/A
Parameter DL205 Range
Start Address ⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠ V See DL205 V-memory map - Data Words
End Address (inclusive) ⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠ V See DL205 V-memory map - Data Words
Result (DWORD Binary) ⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠⸠ V See DL205 V-memory map - Data Words




230
240
250-1
260