AutomationDirect DL205 - Page 504

DL205 User Manual, 4th Edition, Rev. D
5-280
Chapter 5: Standard RLL Instructions
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
ECOM100 Send E-mail (ECEMAIL) (IB-711)
ECOM100 Send EMail, on a leading edge transition, will behave as an EMail client and send
an SMTP request to your SMTP Server to send the EMail message to the EMail addresses
in the To: field and also to those listed in the
Cc: list hard coded in the ECOM100. It will
send the SMTP request based on the specified
ECOM100#, which corresponds to a specific
unique ECOM100 Configuration (ECOM100)
at the top of your program.
The Body: field supports what the PRINT and
VPRINT instructions support for text and
embedded variables, allowing you to embed
real-time data in your EMail (e.g., “V2000 = “
V2000:B).
The Workspace parameter is an internal, private
register used by this IBox and MUST BE
UNIQUE in this one instruction and MUST
NOT be used anywhere else in your program.
Either the Success or Error bit parameter will turn on once the request is complete. If there
is an error, the Error Code parameter will report an ECOM100 error code (less than 100),
an SMPT protocol error (between 100 and 999), or a PLC logic error (greater than 1000).
Since the ECOM100 is only an EMail Client and requires access to an SMTP Server, you
MUST have the SMTP parameters configured properly in the ECOM100 via the ECOM100’s
Home Page and/or the EMail Setup instruction (ECEMSUP). To get to the ECOM100’s
Home Page, use your favorite Internet browser and browse to the ECOM100’s IP Address,
e.g., http://192.168.12.86
You are limited to approximately 100 characters of message data for the entire instruction,
including the To: Subject: and Body: fields. To save space, the ECOM100 supports a hard
coded list of EMail addresses for the Carbon Copy field (cc:) so that you can configure those
IN the ECOM100, and keep the To: field small (or even empty), to leave more room for the
Subject: and Body: fields.
In order for this ECOM100 IBox to function, you must turn ON dip switch 7 on the
ECOM100 circuit board.
DS5 Used
HPP
N/A




230
240
250-1
260