Name Description
IP Mode
IP Mode Specifies the IP Mode value set in the phone.
IP Parameters (Ethernet)
IPv4 Address Specifies the IPv4 address of the phone.
Subnet Mask Specifies the subnet mask of the phone.
IPv4 Gateway Specifies the IPv4 gateway value set in the phone.
IPv6 Address Specifies the IPv6 address of the phone.
IPv6 Link Local Address Specifies the IPv6 link local address of the phone.
IPv6 Gateway Specifies the IPv6 gateway value set in the phone.
SLAAC Address Specifies the SLAAC address of the phone.
IP Parameters (Wifi)
IPv4 Address Specifies the IPv4 address of the phone.
Subnet Mask Specifies the subnet mask of the phone.
IPv4 Gateway Specifies the IPv4 gateway value set in the phone.
Plug-and-Play Configuration
PNP Enabled Specifies whether the PNP configuration is enabled
or disabled.
PNP Status Specifies the PNP status.
Configuration Server Address
HTTPS Server Specifies the address of the HTTPS server.
HTTP Server Specifies the address of the HTTP server.
DNS Server Specifies the address DNS server.
Backup/Restore Server for User data Specifies the address of the Backup/Restore server.
SIP Account
Registration Status Specifies whether the SIP account is registered or
not.
SIP User ID Specifies the SIP user ID.
SIP Domain Specifies the SIP domain.
SIP Proxy Server Specifies the details of the proxy server.
Quality of Service
L2 Audio Specifies the L2 audio value set in the phone.
L2 Signaling Specifies the L2 signalling value set in the phone.
L3 Audio Specifies the L3 audio value set in the phone.
L3 Signaling Specifies the L3 signalling value set in the phone.
802.1x parameters
Table continues…
Configuring the phone using the web interface
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 101
Comments on this document? infodev@avaya.com
To Next Page
Loading...
