4. Click one of the following:
• Save: To save the configuration changes.
• Reset to Default: To revert to the default values.
Network settings field description
Name Description
Network
Network Mode of Operation Specifies the network mode used by the phone.
The operations are:
• Ethernet only
• Ethernet (preferred, but manual override
allowed from Phone UI) (default)
• Wi-Fi (preferred, but manual override allowed
from Phone UI)
DNS
DNS Server Specifies the IP addresses of the DNS servers
added to the network.
Valid value is IP addresses in dotted-decimal
format, separated by commas without any
intervening spaces.
The default value is empty.
Note:
You can add up to 16 DNS servers.
DNS Domain Specifies the domain name of the DNS server.
Valid value must be in the DNS name format. The
default value is empty.
ICMP
Destination Unreachable Message Control Specifies the type of the ICMP destination
unreachable messages.
The options are:
• No
• Limited Port Unreachable messages (default)
• Protocol and Port Unreachable messages
Table continues…
Configuring the phone using the web interface
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 103
Comments on this document? infodev@avaya.com
To Next Page
Loading...
