Name Description
Redirect Message Control Specifies whether the ICMP redirect messages are
processed or not.
The options are:
• Yes
• No (default)
TCP
Send TCP Keep Alive Message Specifies whether the TCP/IP keep-alive messages
are enabled or disabled in the system.
The options are:
• Enable (default)
• Disable
TCP Keep Alive Time Specifies the wait time interval in seconds of the
phone before sending out the TCP keep-alive
message (TCP ACK message) to the far-end.
Valid value is an integer from 10 to 3600. The
default option is 60 seconds.
TCP Keep Alive Interval Specifies the TCP keep-alive packet re-
transmission interval.
Valid value is an integer from 5 to 60. The default
option is 10 seconds.
Web Server
Web Server On HTTP Specifies whether HTTP access to the web
interface is enabled or disabled.
The options are:
• Yes (default)
• No
HTTP Listen Port Specifies the port number of the web server when
the web interface is accessed using HTTP.
The valid value is an integer from 80 to 65535. The
default port number is 80.
HTTPS Listen Port Specifies the port number of the web server when
the web interface is accessed using HTTPS.
The valid value range is from 443 to 65535. The
default port number is 443.
The valid value is an integer from 443 to 65535.
Table continues…
Phone configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 104
Comments on this document? infodev@avaya.com
To Next Page
Loading...
