Avaya J100 Series - Page 203

Parameter Default
value
Description
ALLOW_BLF_LIST_C
HANGE
3 Specifies whether a user can add or delete the monitored phone
extensions from the BLF resource list.
Note:
This parameter is supported only in the Broadworks
environment.
Valid values:
0 – The user cannot add or delete monitored phone extensions.
1 – The user can only delete monitored phone extensions.
2 – The user can only add monitored phone extensions.
3 – The user can add and delete monitored phone extensions.
BLF_INCOMING_CAL
L_INDICATION
3 Specifies the indication type for a BLF incoming call.
Valid values:
• 0 - None (no alerting for BLF incoming calls).
• 1 - Audible (only audible alerting for BLF incoming calls).
• 2 - Visual (only visual alerting for BLF incoming calls).
• 3 - Default (the behavior isl based on
BLF_INCOMING_CALL_INDICATION_MODE parameter
value).
• 4 - Both (both audible and visual alerting for BLF incoming
calls).
Note:
This parameter is supported only in the 3PCC environment.
BLF_PARKED_CALL_
INDICATION
1 Specifies the indication type for a BLF parked call.
Valid values:
• 0 - None (no alerting for BLF parked calls).
• 1 - Default (the behavior based on
BLF_PARKED_CALL_INDICATION_MODE parameter value).
• 2 - Audible (only audible alerting for BLF parked call).
• 3 - Visual (only visual alerting for BLF parked call).
• 4 - Both (default - both audible and visual alerting for BLF
parked call).
Note:
This parameter is supported only in the 3PCC environment.
Table continues…
Feature configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 203
Comments on this document? infodev@avaya.com