Avaya J100 Series - Page 204

Parameter Default
value
Description
BLF_INCOMING_CAL
L_INDICATION_MOD
E
3 Specifies the indication mode for a BLF incoming call.
Valid values:
• 0 - None (no alerting for BLF incoming call).
• 1 - Audible (only audible alerting for BLF incoming call).
• 2 - Visual (only visual alerting for BLF incoming call).
• 3 - Both (both audible and visual alerting for BLF incoming call)
• 4 - Force None (forced only audible alerting for BLF incoming
call).
• 5 - Force Audible (forced only audible alerting for BLF incoming
call).
• 6 - Force Visual (forced only visual alerting for BLF incoming
call).
• 7 - Force Both (forced both audible and visual alerting for BLF
incoming call).
Note:
This parameter is supported only in the 3PCC environment.
BLF_PARKED_CALL_
INDICATION_MODE
1 Specifies the indication move for a BLF parked call.
Valid values:
• 0 - None (no alerting for BLF parked call).
• 1 - Audible (only audible alerting for BLF parked call).
• 2 - Visual (only visual alerting for BLF parked call).
• 3 - Both (both audible and visual alerting for BLF parked call)
• 4 - Force None (forced only audible alerting for BLF parked
call).
• 5 - Force Audible (forced only audible alerting for BLF parked
call).
• 6 - Force Visual (forced only visual alerting for BLF parked
call).
• 7 - Force Both (forced both audible and visual alerting for BLF
parked call).
Note:
This parameter is supported only in the 3PCC environment.
Table continues…
Feature and application configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 204
Comments on this document? infodev@avaya.com