phone does not have the XSI connection then you can configure the disposition code using one of
the following:
• Web interface of the phone
•
46xxsettings.txt file
Note:
The phone refreshes every 30 minutes to load if there are any new disposition codes, or to
load the values immediately you can restart the phone.
Related links
Configuring Settings on page 125
BroadWorks call center parameters
Use the 46xxsettings.txt file to set the following parameters:
Parameter name Default value Description
BS_CC_ENABLED 0 Specifies whether the
BroadWorks Call Center feature
is enabled or disabled. Use this
parameter only if XSI is disabled
(XSI_URL is empty).
Options are:
• 0: Disables the parameter.
• 1: Enables the parameter.
Note:
This parameter is available
in:
• Avaya J159 IP Phone
• Avaya J169/J179 IP Phone
Table continues…
Feature and application configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 210
Comments on this document? infodev@avaya.com
To Next Page
Loading...
