Avaya J100 Series - Page 464

Parameter name Default value Description
SUBSCRIBE_SECURITY 0 Specifies the use of SIP or
SIPS for subscriptions.
Value operation:
0: The phone uses SIP for
both the request URI and
the contact header .
1: The phone uses SIPS
for both the request URI
and the contact header .
TLS is on .
2: SES or PPM does not
show a FS-phoneData
FeatureName with a
Feature Version of 2 in the
response to the
getHomeCapabilities
request
SUBSCRIBELIST Null Specifies a list of URIs to
which the phone will send
a subscribe message after
the phone successfully
registers with a call server,
or when a subscribe push
request is received with a
type attribute all. The
message is an HTTP GET
for the URI with the
phone's MAC address,
extension number, IP
address and model
number appended as
query values)
The list can contain up to
255 characters. Values are
separated by commas
without any intervening
spaces.
If the value is set to null,
subscribe messages are
not sent.
Table continues…
Customizable parameters
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 464
Comments on this document? infodev@avaya.com