Avaya J100 Series - Page 465

Parameter name Default value Description
SYMMETRIC_RTP 1 Specifies if the phone
must discard received
RTP datagrams if their
UDP source port number
is not the same as the
UDP destination port
number included in the
RTP datagrams of that
endpoint.
Value operation:
0: Ignore the UDP source
port number in received
RTP datagrams.
1: Discard received RTP
datagrams (default).
SYSLOG_ENABLED 0 Specifies if Syslog
messages must be send
or not.
Value operation:
0: Sending Syslog
messages is disabled
(default)
1: Sending Syslog
messages is enabled
Table continues…
List of configuration parameters
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 465
Comments on this document? infodev@avaya.com